Hollywood-racks F2 Spoiler Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Pro jízdní kola Hollywood-racks F2 Spoiler. Hollywood Racks F2 Spoiler User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 8
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Model F2 “Over
-
the
-
Top” Bike Carrier Installation
Guide
Comes Fully Assembled Carries up to Two Bikes
1.
Choosing the correct
top straps
This rack includes three types of top
or upper strap attachment systems:
a) Regular Hollywood top straps
with trunk lid hooks (Fig. 3). These
are pre-assembled with the rack.
See section 2
b) Hatch anchors with quick connect
straps. See section 3
c) Roof rack adapter straps with
quick connect straps.
See section 4
On some vehicles, more than one top
strap attachment system can be
used. Determining the best one may
require ruling out the other two.
Continued on page 2
Fig. 1
For quick-start instructions, scan QR
Code or go to hollywoodracks.com/f2
Install the F2 on structurally sound trunks, hatches, roof rack load
bars and roof rack raised side rails only.
Never attach hooks to plastic, glass, fiberglass or carbon fiber.
Clean the surface of the trunk or hatch before installation of the rack.
Tighten all six straps before AND after mounting bikes on the rack.
Maximum capacity is two bikes, 35 lbs/16kg per bike.
Always use the safety strap after loading and tying down bikes.
Keep bicycle tires min. 1ft/30cm away from vehicle exhaust pipe.
Check rack, bikes and straps regularly during use.
Drive slowly when used on bumpy or dirt surface roads.
The F2 Over
-
the
-
Top rack has been specially designed to fit SUVs, mini
-
vans and hatch
-
backs equipped
with rear spoilers or wind deflectors. The rack uses an adjustable “spoiler clearance frame” to prevent the
top or uppermost straps of the rack from making contact with the spoiler. The F2 will also fit most vehicles
without spoilers.
Fig. 2:
Parts
included
with
F2 Rack
1
Zobrazit stránku 0
1 2 3 4 5 6 7 8

Shrnutí obsahu

Strany 1 - Choosing the correct

Model F2 “Over-the-Top” Bike Carrier InstallationGuideComes Fully Assembled – Carries up to Two Bikes1. Choosing the correct top strapsThis rack inclu

Strany 2 - Upper Straps

Note: depending on the tightness of the cups, you may also need to unlock one or both of the levers on the lower hubs.b) Next, unlock the upper hubs a

Strany 3

Fig. 15a3h)Attach the hooks on the lower straps to the bottom of the trunk or hatch lid and pull snug. See Fig. 15a.Note that the lower strap‘s buckle

Strany 4 - Hatch Anchors

43.Installation Using Hatch Anchors The hatch anchors included with the F2(Fig. 16) fit between your rear hatch and vehicle body. They are used when

Strany 5 - Installation on vehicle:

4. Installation Using Roof Rack Adapter Straps These padded straps provide a convenient location for top strap attachment when regular upper strapsor

Strany 6 - 5. Mounting bikes on rack

6Fig.30Fig. 31Fig. 33aFig. 29Included with the rack are 6 rubber straps (1 each for the regular cradles (Fig. 30) and 2 each for the anti-sway cradles

Strany 7 - 6. Fit Gallery

7Fig. 34Fig. 35Fig. 36Fig. 37Fig. 38Fig. 34: Correct spoiler clearance frame positionon small square back with spoiler.Fig. 35: Correct Spoiler cleara

Strany 8 - Hollywood Racks

Limited Lifetime Warranty (effective January 1, 2008):Hollywood Racks will warranty its car racks and accessories during the time that an original ret

Komentáře k této Příručce

Žádné komentáře